 |
Cycle Use - direct power source: It can provide the power supply to power tools, portable electronic products. It can also be used for cycling charging and discharging usage such as electronics motorbike or vacuum cleaner. Standby Use - back More>> |
|
1. Do not mix brands, models and date codes. 2. No separate discharge then charging in a serial configuration. 3. Under parallel usage, pay close attention to the differences in voltage in each circuit. 4. If the difference in voltage in eac More>> |
|
Reserve capacity is the number of minutes a battery can maintain a useful voltage under a 25 ampere discharge. The higher the minute rating, the greater the batterys ability to run lights, pumps, inverters, and electronics for a longer peri More>> |
|
One cycle of a battery is a discharge from full charge to full discharge and a return to full charge again. The total number of cycles a battery can perform before failure is called its Cycle Life. Moat battery manufacturers will not discus More>> |
|
Deep-cycle batteries are used when 50% or more of the capacity is used per cycle. The most common use of deep-cycle batteries is in applications that require deep, repetitive drain, like powerful car audio systems, trolling motors, golf cart More>> |
|
Different usage applications will use different methods for evaluating a batterys performance. Using a 20 hour rate or the 10 hour rate, you can use 0.05CA or 0.1CA to discharge the battery until the battery reaches a terminal voltage of 10. More>> |
|
The most common battery rating is the AMP-HOUR RATING. This is a unit of measurement for battery capacity, obtained by multiplying a current flow in amperes by the time in hours of discharge. (Example: A battery which delivers 5 amperes for More>> |
|
